Double-sided adhesive stickers the right way:
1, we have before pasting the plate, tape and stick cylinders placed in the same room at a time;
2, before pasting, we must stick to the plate cylinder and clean;
3, if the sleeve posted version, you must use the minimum air pressure to prevent deformation of the sleeve;
4, double-sided tape joints should be staggered junction with the plate;
5, taping, preferably with a squeegee in a parallel manner swept tape affixed to the drum evenly, between the tape and the plate roller can not leave bubbles; (if retained application to pierce the bubbles excluded)
6. In determining the position of the plate, the plate with tape to avoid premature exposure to determine the print position, while removing the protective layer tape edge the plate with a squeegee to sweep parallel manner affixed to the tape;
7, in the printing process to clean the plates, cleaning solvents should avoid contact with the tape, to avoid damage to the tape;
8, when the plate is removed from the tape, the tape between the plate and the angle should not exceed 90 degrees.
9, the local version of the interface to stay around 5mm, use 3M 1600 Electrical insulating tape seal version works well, can effectively avoid the Wiping the ink caused by pollution warped version of the interface, and very economical.
10, double-sided adhesive over repeated use will have adverse overprint phenomenon, especially in the new version is a change, it is easy to use for a long time the situation occurred and when.