Japan imported 3M9448A double-sided tape at the bonding, adjustment shall be the following manner, enhanced bonding effect can be obtained:
 
1, the first surface of the adhesive must be cleaned and dried with a cloth dampened with a general recommendation 1: 1IPA (isopropyl alcohol) with a mixture of water surface wipe cleaned, until the surface is completely dry.
 
2, after the solvent to be cleaned and dried, the adhesive tape bonded to the surface, or otherwise applied to the drum about 15PSI (1.05 kg / cm) of the pressure, so that the effective bonding.
 
3, the tape release paper tear-off, and then will need to fit the material paste, the same applied 15PSI pressure, make it effective fit. To remove air bubbles, should increase the pressure to the article to withstand a ceiling limit.
 
4, paste the desired temperature is 15-38 ℃, do not lower than 10 ℃.
 
5, adhesive tape, should be fit after the end of the first, and then slowly push to the other side, in order to reduce the probability of bubbles generated.
 
3M double-sided adhesive suitable environment requires storage: a temperature of 19-23 ℃, humidity of 40-60%.